When set to “F”, the output is not set by any drive function but it can be switched by a PLC via MEMOBUS/Modbuscommunications interface (through mode).Setting 10: Minor FaultOutput closes when a minor fault condition is present.Setting 1A: During ReverseThe During Reverse digital output will close whenever the drive is turning the motor in the reverse direction.Status DescriptionOpen Motor is driven in the forward direction or stopped.Closed Motor is driven in reverse.Output frequencytimeFWD Run commandREV Run commandDuring Reverse OFF ONFigure 5.25 Reverse Direction Output Example Time ChartSetting 1E: Restart EnabledThe Restart Enabled output will be closed once the fault restart function becomes active and will remain closed until a successfulrestart is accomplished or the number of Auto Restart attempts as specified by L5-01 is reached. Refer to L5: Fault Restarton page 117 for details on automatic fault restart.Setting 3C: LOCAL/REMOTE StatusOutput terminal closes while the drive is set for LOCAL and opens when in REMOTE.Status DescriptionOpen REMOTE: The selected external reference (b1-01/02 or MEMOBUS/Modbus) is used as frequency reference and Run command sourceClosed LOCAL: The digital operator is used as frequency reference and Run command sourceSetting 3D: During Speed SearchOutput terminal closes while Speed Search is being performed.Setting 100 to 13D: Reverse Switching for Functions 0 to 3DThese settings reverse the switching status of the specified function. Set as 1oo, where the last two digits specify the settingnumber of the function to be reversed.Examples:• To reverse the output for “8: During Baseblock”, set “108”.• To reverse the output for “3C: Run command” set “13C”.u H3: Analog Input Terminal A1 SettingsThese parameters adjust the signal level and characteristics of the analog frequency reference input A1.n H3-01: Terminal A1 Signal Level SelectionSelects the input signal level for analog input A1.No. Name Setting Range DefaultH3-01 Terminal A1 Signal Level Selection 0 to 3 05.6 H: Terminal FunctionsYASKAWA ELECTRIC SIEP C710606 31B YASKAWA AC Drive – J1000 Technical Manual 1075 Parameter Detailshttp://nicontrols.com
