n Ferrule-Type Wire TerminationsCrimp a ferrule to signal wiring to improve wiring simplicity and reliability. Use CRIMPFOX ZA-3, a crimping toolmanufactured by PHOENIX CONTACT.d1d2 6 mmLFigure 3.12 Ferrule DimensionsTable 3.9 Ferrule Terminal Types and SizesSize mm2 (AWG) Type L (mm) d1 (mm) d2 (mm) Manufacturer0.25 (24) AI 0.25-6YE 10.5 0.8 2.0PHOENIX CONTACT0.34 (22) AI 0.34-6TQ 10.5 0.8 2.00.5 (20) AI 0.5-6WH 12 1.1 2.50.75 (18) AI 0.75-6GY 12 1.3 2.81.0 AI 1-6RD 12 1.5 3.0u Wiring ProcedureThis section describes the proper procedures and preparations for wiring the control terminals.WARNING! Electrical Shock Hazard. Do not remove covers or touch the circuit boards while the power is on. Failure to comply could resultin death or serious injury.NOTICE: Separate control circuit wiring from main circuit wiring (terminals R/L1, S/L2, T/L3, B1, B2, U/T1, V/T2, W/T3, -, +1, +2) and otherhigh-power lines. Improper wiring practices could result in drive malfunction due to electrical interference.NOTICE: Separate wiring for digital output terminals MA, MB and MC from wiring to other control circuit lines. Improper wiring practicescould result in drive or equipment malfunction or nuisance trips.NOTICE: Use a class 2 power supply (UL standard) when connecting to the control terminals. Improper application of peripheral devicescould result in drive performance degradation due to improper power supply.NOTICE: Insulate shields with tape or shrink tubing to prevent contact with other signal lines and equipment. Improper wiring practices couldresult in drive or equipment malfunction due to short circuit.NOTICE: Connect the shield of shielded cable to the appropriate ground terminal. Improper equipment grounding could result in drive orequipment malfunction or nuisance trips.Wire the control terminals using Figure 3.13 as a guide. Prepare the ends of the control circuit wiring as shown in Figure3.14. Refer to Wire Size and Torque Specifications on page 44.NOTICE: Do not tighten screws beyond the specified tightening torque. Failure to comply may damage the terminal.NOTICE: Use shielded twisted-pair cables as indicated to prevent operating faults. Improper wiring practices could result in drive orequipment malfunction due to electrical interference.Connect control wires as shown in the following figure:3.7 Control Circuit WiringYASKAWA ELECTRIC SIEP C710606 31B YASKAWA AC Drive – J1000 Technical Manual 453 Electrical Installationhttp://nicontrols.com