u H Parameters: Multi-Function TerminalsH parameters assign functions to the multi-function input and output terminals.No. Name Description Range Def. Mode Addr.Hex Pg.H1: Multi-Function Digital InputH1 parameters to assign functions to the multi-function digital input terminals. Unused terminals should be set to "F".H1-01 Multi-Function Digital InputTerminal S1 FunctionSelectionAssigns a function to the multi-function digital inputs.Refer to H1 Multi-Function Digital Input Selections onpage 194 for a description of setting values.1 to 6740 O 438 98H1-02 Multi-Function Digital InputTerminal S2 FunctionSelection 41 O 439 98H1-03 Multi-Function Digital InputTerminal S3 FunctionSelection0 to 6724 O 400 98H1-04 Multi-Function Digital InputTerminal S4 FunctionSelection 14 O 401 98H1-05 Multi-Function Digital InputTerminal S5 FunctionSelection3 (0)<1> O 402 98<1> Parenthetical value is the default when parameter A1-03 = 3330 3-Wire Initialization.H1 Multi-Function Digital Input SelectionsH1-ooSetting Function Description Page0 3-Wire Sequence Closed: Reverse rotation (only if the drive is set up for 3-Wire sequence) 981 LOCAL/REMOTE Selection Open: REMOTE, Run and frequency reference source set in b1-01/02Closed: LOCAL, LED operator is run and reference source 992 Serial Communication ReferenceSelection Open: REMOTE, Run and frequency reference source set in b1-01/02Closed: MEMOBUS/Modbus Communication 993 Multi-Step Speed Reference 1Used to select Multi-Step Speeds set in d1-01 to d1-08994 Multi-Step Speed Reference 2 995 Multi-Step Speed Reference 3 996 Jog Reference Selection Open: Selected speed referenceClosed: Jog Frequency reference (d1-17). Jog has priority over all other referencesources. 997 Accel/Decel Time 1 Used to switch between Accel/Decel Time 1 and 2 998 Baseblock Command (N.O.) Open: Normal operationClosed: No drive output 1009 Baseblock Command (N.C.) Open: No drive outputClosed: Normal operation 100A Accel/Decel Ramp Hold Closed: The drive pauses during acceleration or deceleration and maintains theoutput frequency. 100F Not used Select this setting when not using the terminal or when using the terminal in apass-through mode. 10010 Up Command Open: Maintains the current frequency referenceClosed: Increases or decreases the current frequency reference.Ensure that the increase and decrease commands are set in conjunction with oneanother.10011 Down Command 10014 Fault Reset Closed: Resets faults if the cause is cleared and the Run command is removed. 10115 Fast-Stop (N.O.) Closed: Decelerates at the Fast-Stop time C1-09.To restart the Fast-Stop input must be released and Run must be cycled. 10217 Fast-stop (N.C.) Open: Decelerates according to C1-09 (Fast-stop Time) 102B.2 Parameter Table194 YASKAWA ELECTRIC SIEP C710606 31B YASKAWA AC Drive – J1000 Technical Manualhttp://nicontrols.com
