5.9 o: Operator Related SettingsThese parameters concern the various functions and features of the digital operator.u o1: Display Settings and SelectionsThese parameters determine how data is shown on the operator display.n o1-02: User Monitor Selection after Power UpSelects which monitor parameter will be displayed upon power up. Defaulted to show the frequency reference when the driveis first turned on.No. Name Setting Range Defaulto1-02 User Monitor Selection after Power Up 1 to 4 1Setting 1: Frequency Reference (U1-01)Setting 2: Forward/ReverseSetting 3: Output Frequency (U1-02)Setting 4: Output Current (U1-03)n o1-03: Digital Operator Display SelectionSets the units used to display the frequency reference and output frequency.No. Name Setting Range Defaulto1-03 Digital Operator Display Selection 0 or 1 0Setting 0: 0.01 Hz UnitsSetting 1: 0.01% Units (100% = Max. Output Frequency)Note: Parameter o1-03 allows the user to change units used in the following parameters and monitors:U1-01, Frequency ReferenceU1-02, Output Frequencyd1-01 to d1-08, Frequency References 1 to 8u o2: Operator Key SelectionsThese parameters determine the functions assigned to the operator keys.n o2-02: STOP Key Function SelectionSelects if the STOP key on the digital operator can be used to stop the operation when the drive is controlled from a remotesource (i.e., not from digital operator).No. Name Setting Range Defaulto2-02 STOP Key Function Selection 0 or 1 1Setting 0: DisabledThe STOP key has no function when the drive is controlled by a source other than the digital operator. The drive can only bestopped from the Run command source that has been selected.Setting 1: EnabledThe STOP key can be used to terminate the operation, even if the Run command source is not assigned to the digital operator.If operation has been interrupted by pressing the STOP key, the Run command must be cycled to restart the drive.n o2-04: Drive Model SelectionParameter o2-04 matches the control board to the drive hardware. Proper setting of o2-04 is important for optimal performanceand proper protection for the drive hardware. This parameter is configured at the factory and does not normally requireadjustment in the field. It is available primarily to accommodate control board replacement in the event of damage.5.9 o: Operator Related Settings122 YASKAWA ELECTRIC SIEP C710606 31B YASKAWA AC Drive – J1000 Technical Manualhttp://nicontrols.com
