B.2 Parameter TableAn “O” in the “Mode” column indicates that the parameter is available in the Advanced menu.An “S” in the “Mode” column indicates that the parameter is available in the Startup menu.u A: Initialization ParametersThe A parameter group creates the operating environment for the drive. This includes the parameter Access Level, andPassword.No. Name Description Range Def. Mode Addr.Hex Pg.A1: Initialization ParametersUse A1 parameters to configure the basic environment for drive operation.A1-01<1> Access LevelSelectionSelects which parameters are accessible via the digital operator.0: Operation only2: Advanced Access Level 0, 2 2 O 101 76A1-03 InitializeParametersResets all parameters to factory default settings. (Initializes the drivethen returns A1-03 to 0)0: No Initialize2220: 2-Wire Initialization3330: 3-Wire Initialization0 to 3330 0 O 103 76E1-03, L8-35, o2-04, o2-09, and all U2 monitorsare not reset when performing initialization.A1-04 Password 1When the value set into A1-04 does not match the value set intoA1-05, parameters A1-01 and A1-03 cannot be changed.0 to 9999 0 O 104 76A1-05 Password 20 to 9999 0 O 105 76This parameter is hidden from view. To accessA1-05, first display A1-04. Then press the STOPkey while holding down the up arrow key.Parameter A1-05 will appear.<1> Parameter can be changed during run.u b: ApplicationApplication parameters configure the Run Command Source, DC Injection Braking, and other application-related settings.No. Name Description Range Def. Mode Addr.Hex Pg.b1: Operation Mode SelectionUse b1 parameters to configure the operation mode.b1-01 FrequencyReferenceSelectionSelects the frequency reference input source.0: Operator - Digital preset speed d1-01 to d1-081: Terminals - Analog input terminal A12: MEMOBUS/Modbus communications (option)3: Potentiometer (option)0 to 3 1 S 180 79b1-02 Run CommandSelectionSelects the run command input source.0: Operator - RUN and STOP keys on the digital operator1: Digital input terminals2: MEMOBUS/Modbus communications (option)0 to 2 1 S 181 80b1-03 Stopping MethodSelectionSelects the stopping method when the run command is removed.0: Ramp to Stop1: Coast to Stop 0, 1 0 S 182 81b1-04 Reverse OperationSelectionPermits or prohibits reverse operation.0: Reverse enabled.1: Reverse disabled. 0, 1 0 O 183 82b1-07 LOCAL/REMOTERun SelectionDetermines the operation when the Run command source is switchedfrom LOCAL to REMOTE or between REMOTE and MEMOBUS/Modbus communication.0: External Run command has to be cycled at the new source to beactivated.1: External Run command at new source is accepted immediately.0, 1 0 O 186 82b1-08Run CommandSelection while inProgrammingMode0: Run command accepted only in the operation menu.1: Run command accepted in all menus.2: Prohibit entering Programming Mode during Run 0 to 2 0 O 187 82B.2 Parameter TableYASKAWA ELECTRIC SIEP C710606 31B YASKAWA AC Drive – J1000 Technical Manual 189B Parameter Listhttp://nicontrols.com
