9 Arc Welding Application9.12 Power Source Condition File9-88149235-1CDRE-CSO-A0319.12.3 POWER SOURCE CONDITION WindowA Power Source condition data file has the following two windows:• POWER SOURCE CONDITION Window• POWER SOURCE CONDITION Window (for current/voltage output) POWER SOURCE CONDITION WindowPOWER SOURCE NO. (1 to 4)Displays a Power Source number between 1 and 4 (for each welder).SETTINGIf this file is modified, the status automatically changes to “NONE,” indicating that themodification is not saved yet. To save the modification to the file, move the cursor to“SETTING” and press [SELECT]. Then the status changes to “DONE.”POWER SOURCE NAMEDisplays a Power Source name of 16 characters or less.COMMENTDisplays a comment of 32 characters or less.POWER SUPPLY (A/V, A/%)When “A/%” is displayed: Measured values of voltage can be input by the unit of “%” for “MEASURE” in the POWER SOURCE CONDITION window forcurrent/voltage output shown in the next page.When “A/V” is displayed: Measured values of voltage can be input by the unit of “V” for “MEASURE” in the POWER SOURCE CONDITION window forcurrent/voltage output shown in the next page.*To switch between “A/%” and “A/V” in the POWER SOURCE CONDITION window, select[DATA] -> [READING] to read the initial value file (maker offer) or user registered file onceagain.*This function is available for the standard software version NS4.00.00A ()-00 or later.SHIELDING GAS (CO2,MAG)Specifies the shielding gas type.WIRE DIA. (0 to 9.9mmΦ)Specifies the wire diameter.WIRE STICKOUT (0 to 99mm)Specifies the length of the welding wire protruding from the torch tip.DATA EDIT DISPLAY UTILITYPOWER SOURCE CONDITIONPOWER SOURCE NO.: 1/1SETTINGPOWER SOURCE NAMECOMM.POWER SUPPLYSHIELDING GASWIRE DIA.WIRE STICKOUTWIRE ANTI-STICKINGARC FAILURE STOP: DONE: MOTOWELD-E350: STC CONTROL NONE: A/%: CO2: 0.1 mm: 15 mm: 0.1 sec: 1.50 sec431 of 493
