1 - 3GENINFOEB101030LOCK WASHERS/PLATES AND COTTERPINS1.Replace all lock washers/plates 1 and cotterpins after removal. Bend lock tabs along thebolt or nut flats after the bolt or nut has beentightened to specification.EB101040BEARINGS AND OIL SEALS1.Install bearings and oil seals so that themanufacturer’s marks or numbers are visible.When installing oil seals, apply a lightcoating of lightweight lithium base grease tothe seal lips. Oil bearings liberally wheninstalling, if appropriate.1 Oil sealCAUTION:Do not use compressed air to spin thebearings dry. This will damage the bearingsurfaces.1 BearingEB101050CIRCLIPS1.Check all circlips carefully beforereassembly. Always replace piston pin clipsafter one use. Replace distorted circlips.When installing a circlip 1, make sure thatthe sharp-edged corner 2 is positionedopposite the thrust 3 it receives. Seesectional view.4 ShaftIMPORTANT INFORMATION
