7 - 29DRIVREAR AXLE/FINAL DRIVE GEAR AND DRIVE SHAFT3.Apply: Sealant (Quick Gasket®)(to the mating surfaces of the swingarm andthe final drive gear case)Sealant (Quick gasket®):P/N. ACC-11001-05-01Yamaha bond No.1215:P/N. 90890-855054.Install: Final drive gear Nuts BoltsLTT R..63 Nm (6.3 m • kg, 45 ft • lb)LTT R..63 Nm (6.3 m • kg, 45 ft • lb)5.Install: Dust cover Rear axle*****************************************************Installation steps: Install the dust cover 1 onto the rear axle.NOTE:Adjust the length a to 210.1 mm (8.3 in) wheninstalling the dust cover. Install the rear axle (with dust cover) 2. Install the rear brake drum and rear wheelhub (left). Temporarily tighten the left axle nut 3.NOTE:After tightening the rear axle nut 3, theposition of the dust cover 1 will slightly moveto protect the oil seal of the final gear case.*****************************************************
