8 - 50CHASREAR SHOCK ABSORBER AND SWINGARMINSTALLING THE REAR AXLE HOUSING1.Install: Rear axle housing Final gear case assembly Rear axle(with dust seal)*****************************************************Installation steps: Install the drive shaft.Refer to “REAR AXLE/FINAL DRIVE GEARAND DRIVE SHAFT” in CHAPTER 7. Apply sealant (Quick Gasket®) to the matingsurfaces of the swingarm and the final gearcase. Temporarily install the rear axle housing 1and final gear case assembly 2 on theswingarm. The bolts and nuts 3 ~ 5 shouldbe temporarily tightened. Install the rear axle (with dust seal) 6 fromthe left side of the machine.Refer to “REAR AXLE/FINAL DRIVE GEARAND DRIVE SHAFT” in CHAPTER 7. Tighten the bolts and nuts 3 ~ 5 in thespecified order.3 Nut (×4)4 Bolt (×4)5 Bolt/nut (×4)*****************************************************T R. .Nut 3:63 Nm (6.3 m • kg, 45 ft • lb)LOCTITE®Bolt 4:63 Nm (6.3 m • kg, 45 ft • lb)LOCTITE®Nut 5:63 Nm (6.3 m • kg, 45 ft • lb)
