DRIVING AND OPERATING 191ON/RUN/START (Green IndicatorLight) : This mode is for driving andstarting. With the ignition off, and thebrake pedal applied, pressing thebutton once will place the ignitionsystem in ON/RUN/START. Onceengine cranking begins, release thebutton. Engine cranking will continueuntil the engine starts. See Starting theEngine 0 191. The ignition will thenremain in ON/RUN.Service ModeThis power mode is available forservice and diagnostics, and to verifythe proper operation of themalfunction indicator lamp as may berequired for emission inspectionpurposes. With the vehicle off, and thebrake pedal not applied, pressing andholding the button for more thanfive seconds will place the vehicle inService Mode. The instruments andaudio systems will operate as they doin ON/RUN, but the vehicle will not beable to be driven. The engine will notstart in Service Mode. Press thebutton again to turn the vehicle off.Starting the EngineMove the shift lever to P (Park) orN (Neutral). To restart the enginewhen the vehicle is already moving,use N (Neutral) only.CautionDo not try to shift to P (Park) if thevehicle is moving. If you do, youcould damage the transmission.Shift to P (Park) only when thevehicle is stopped.CautionIf you add electrical parts oraccessories, you could change theway the engine operates. Anyresulting damage would not becovered by the vehicle warranty. SeeAdd-On Electrical Equipment 0 248.Starting Procedure1. With the Keyless Access system,the Remote Keyless Entry (RKE)transmitter must be in thevehicle. Press ENGINE START/STOP with the brake pedalapplied. When the engine beginscranking, let go of the button.The idle speed will go down asthe engine gets warm. Do notrace the engine immediatelyafter starting it.If the RKE transmitter is not inthe vehicle, if there isinterference, or if the RKEbattery is low, a DriverInformation Center (DIC) willdisplay a message. See RemoteKeyless Entry (RKE) SystemOperation 0 30.CautionCranking the engine for longperiods of time, by returning theignition to the START positionimmediately after cranking hasended, can overheat and damagethe cranking motor, and drain thebattery. Wait at least 15 secondsbetween each try, to let thecranking motor cool down.
