User Manual UMN:CLIV5812G105Fig. 6.2 IP Source RoutingTo perform ping test as the route which the manager designated, use the following steps.Step 1 Enable IP source-routing function from the equipment connected to PC which the PINGtest is going to be performed.To enable/disable IP source-routing in the V5812G, use the following command.Command Mode Descriptionip icmp source-route Global Enable IP source-routing function.no ip icmp source-route Disable IP source-routing function.Step 2 Perform the ping test from PC as the designate route with the ping command.6.3.3 Tracing Packet RouteYou can discover the routes that packets will actually take when traveling to theirdestinations. To do this, the traceroute command sends probe datagrams and displaysthe round-trip time for each node.If the timer goes off before a response comes in, an asterisk (*) is printed on the screen.Command Mode Descriptiontraceroute [WORD]EnableTraces packet routes through the network.WORD: destination IP address or host nameA.B.C.D: destination IP addresstraceroute ip A.B.C.Dtraceroute icmp WORD
