UMN:CLI User ManualV5812G164To attach a policy to an interface, use the following command.Command Mode Descriptioninterface-binding port ingress{PORTS | cpu | any }PolicyAttaches the policy to a specified ingress port or anyport.PORTS: port numberinterface-binding port egress{PORTS | cpu | any }Attaches the policy to a specified egress port or anyport.PORTS: port numberinterface-binding vlan { VLANS |any }Attaches the policy to a specified vlan or any vlan.VLANS: VLAN ID (1-4094)To detach a policy from an interface, use the following command.Command Mode Descriptionno interface-binding portingress [PORTS]PolicyRemoves an attached policy from ingress port.no interface-binding port egress[PORTS] Removes an attached policy from egress port.no interface-binding vlan Removes an attached policy from vlan.7.6.4.7 Applying and Modifying PolicyAfter configuring a policy using the above commands, apply it to the system with thefollowing command. If you do not apply the policy to the system, all specifiedconfigurations from Policy Configuration mode will be lost.To save and apply a policy, use the following command.Command Mode Descriptionapply policy Applies a policy to the system.To modify a policy, use the following command.Command Mode Descriptionpolicy NAME modify Global Modifies a policy, enter a policy name.7.6.5 Displaying RuleTo show a rule profile configured by user, use the follwing command.Command Mode Descriptionshow flow-profile Flow Shows a profile of flow.show policer-profile Policer Shows a profile of policer.show policy-profile Policy Shows a profile of policy.
