User Manual UMN:CLIV5812G95The threshold of the port is set to the maximum rate of the port by default.You can also set the blocking timer. When incoming traffic via a given port exceeds aconfigured threshold, the port will discard that traffic during a specified time.To set the blocking timer, use the following command.Command Mode Descriptionthreshold port PORTS blocktimer <10-3600> BridgeSets the blocking timer.PORTS: port number10-3600: blocking time (unit: second)no threshold port PORTS block Disables the blocking timerTo display the configured threshold of port traffic, use the following command.Command Mode Descriptionshow port thresholdEnableGlobalBridgeShows the configured threshold of port traffic.6.1.13.3 Fan OperationThe system fan will operate depending on measured system temperature. To set thethreshold of fan operation, use the following command.Command Mode Descriptionthreshold fan START-TEMPSTOP-TEMP GlobalSets the threshold of fan operation in the unit ofCelsius (°C).START-TEMP: starts fan operation. (default: 30)STOP-TEMP: stops fan operation. (default: 0)no threshold fan Deletes a configured threshold of fan operation.When you set the threshold of fan operation, START-TEMP must be higher than STOP-TEMP.To display the configured threshold of fan operation, use the following command.Command Mode Descriptionshow status fanEnableGlobalBridgeShows the status and configured threshold of fanoperation.i!
