UMN:CLI User ManualV5812G116To display a granted SNMP group to access to a specific SNMP view record, use thefollowing command.Command Mode Descriptionshow snmp accessEnableGlobalBridgeShows a granted SNMP group to access to a specificSNMP view record.7.1.7 SNMP Version 3 UserIn SNMP version 3, you can register an SNMP agent as user. If you register an SNMPversion 3 user, you should configure it with the authentication key.To create/delete an SNMP version 3 user, use the following command.Command Mode Descriptionsnmp user USER {md5 | sha}AUTH_KEY [des PRIVATE_KEY] GlobalCreates an SNMP version 3 user.no snmp user USER Deletes a registered SNMP version 3 user.To display a current SNMP version 3 user, use the following command.Command Mode Descriptionshow snmp userEnableGlobalBridgeDisplays an SNMP version 3 user.7.1.8 SNMP TrapSNMP trap is an alert message that SNMP agent notifies SNMP manager about certainproblems. If you configure the SNMP trap, the system transmits pertinent information tonetwork management program. In this case, trap message receivers are called a traphost.7.1.8.1 SNMP Trap ModeTo select the SNMP trap mode, use the following command.Command Mode Descriptionsnmp trap-mode {alarm-report |event} GlobalSelects the SNMP trap mode.alarm-report: alarm report based trapevent: event based trap (default)
