UMN:CLI User ManualV5812G498To enable/disable the MAC bridge port configuration of MAC bridge service profile formulticast Interworking Termination Point (IW TP), use the following command.Command Mode Descriptionmulticast link-mac-bridgeenable Traffic-BridgeConnects the multicast GEM port network CTP ME to aMAC bridge service profile ME. (default)multicast link-mac-bridgedisableDisables the connections between the multicast GEMport network CTP ME to the MAC bridge serviceprofile.11.5.3.4 ANI Port ConfigurationTo enable/disable a connection between MAC bridge service profile and a mapper ID, usethe following command.Command Mode Descriptionani mapper MAPPER_ID Traffic-BridgeConnects a MAC bridge service profile with a mapperID.MAPPER_ID: 1 to 4no ani mapper MAPPER_ID Disconnects a mapper ID from the MAC bridge serviceprofile.If there are more than one mapper connected to a MAC bridge service profile, you needto configure a VLAN tagging filtering for VLAN ID-based traffic forwarding. Toenable/disable VLAN tagging filtering function on ANI interface, use the followingcommand.Command Mode Descriptionvlan-filter vid <1-4094>untagged {allow | discard} TrafficBridge-ANIEnables a VLAN tagging filtering function of ANI-sideport.allow: forwards the untagged frames to the ANI-sideportdiscard: blocks the untagged frames to the ANI-sideport1-4094: VLAN ID(s)no vlan-filter Disables the VLAN tagging filtering function.11.5.3.5 UNI Port ConfigurationA UNI-side port is an ONU device port connected to a subscriber. To enable/disable aconnection between a MAC bridge service profile and UNI-side port for the downstreamtraffic, use the following command.Command Mode Descriptionuni {eth | virtual-eth} UNI-PORTTrafficBridgeConnects an UNI port of ONT to a specified MACbridge service profile.UNI-PORT: UNI port numberno uni {eth | virtual-eth} UNI-PORTRemoves the UNI port of ONT from the MAC bridgeservice profile.
