UMN:CLI User ManualV5812G49011.3.3.4 IGMP Group ListYou can configure the maximum number of multicast groups that a host on a port can join.To specify the maximum number of IGMP groups per UNI-side port, use the followingcommand.Command Mode Descriptionuni eth UNI-PORT igmp max-groups <0-255> ONU-ProfileSpecifies the maximum number of IGMP groups for aport.UNI-PORT: UNI port number0-255: number of IGMP groups (default: 16)no uni eth UNI-PORT igmp max-groups Deletes a specified maximum number of IGMP groups.11.3.3.5 Activating Administration for Ethernet UNITo enable/disable the administration of the Ethernet UNI port, use the following command.Command Mode Descriptionuni eth UNI-PORT port-admin{enable | disable} ONU-Profile Enables/disables the administration of Ethernet UNIport on the specified ONU.To see the admin status of the ONU (ONT) UNI, use show onu uni-status command.(See 11.2.11 Displaying ONU Information)11.3.3.6 Mapping between T-CONT ID and DBA profileTo specify the GEM ports (priority queue) per T-CONT and the bandwidth of GEM port bymapping between T-CONT ID and DBA profile, use the following command.Command Mode Descriptiontcont TCONT-ID dba-profile DBA-PROFILEONU-ProfileSpecifies the priority queues of T-CONT by mappingbetween the DBA profile and T-CONT ID. Sets T-CONT‘s bandwidth by specifying the DBA profileDBA-PROFILE: DBA profile nameno tcont TCONT-ID dba-profile Disables the mapping between T-CONT ID and DBAprofile.11.3.4 Saving ProfileAfter configuring an ONU profile, you need to save the profile with the following command.Command Mode Descriptionapply ONU-Profile Saves an ONU profile configuration.If you modify a running ONU profile, you also need to use the apply command to applythe changes to ONUs (ONTs). If you do not, it will not be applied.ii
