User Manual UMN:CLIV5812G471To display the information of source MAC monitoring, use the following command.Command Mode Descriptionshow olt srcmac-monitor [OLT-ID] GPON Shows the configured source MAC address monitoringfor OLT.show olt srcmac-monitor GPON-OLT11.2.9 POTS Interface ConfigurationTo configure the parameters of POTS interface in an ONT, use the following command.Command Mode Descriptiononu voip-sip ONU-ID phone-number pots POTS-NUMBERNUMBER [display DISPLAY] GPON-OLTSaves a phone number and a display information of aspecified phone device connected to POTS interface atan ONU managed by OMCI protocol.ONU-ID: 1-64 or ONU serial numberPOTS-NUMBER: POTS port numberNUMBER: phone numberDISPLAY: display informationno onu voip-sip ONU-ID phone-number pots POTS-NUMBER Deletes the configured data parameters of VoIP user.For the enhanced system security, the V5812G can use authentication for a VoIP user tohave access to the softswitch.To configure the authentication user name and password for VoIP user to have access tosoftswitch, use the following command.Command Mode Descriptiononu voip-sip ONU-ID auth potsPOTS-NUM NAME [PASSWD]GPON-OLTConfigures an user ID and password for a specifiedVoIP device connected to an ONU to have access tosoftswitch.ONU-ID: 1-64 or ONU serial numberPOTS-NUM: POTS port numberNAME: user name used for authenticationPASSWD: password used for authenticationno onu voip-sip ONU-ID authpots POTS-NUMDeletes the configured authentication information forVoIP user.To display VoIP service and VoIP line status information, use the following command.Command Mode Descriptionshow onu voip line ONU-ID GPON-OLT Shows the information of VoIP service and line status.ONU-ID: 1-64 or ONU serial number
