UMN:CLI User ManualV5812G45010.3.16.1 Displaying RIP Protocol InformationTo display RIP information, use the following command.Command Mode Descriptionshow ip rip [database]EnableGlobalBridgeShows RIP information being used in router.show ip route [database] rip Shows a routing table information involved in RIP.show ip protocols [rip] Shows a current status of RIP protocol and itsinformation.show ip rip interface[INTERFACE] Enable Shows RIP information of specified interface.To clear RIP information being used in router, use the following command.Command Mode Descriptionclear ip rip route [bgp | connected | kernel |ospf | rip | static | all | A.B.C.D/M]EnableGlobalBridgeDeletes RIP information being used inrouter.10.3.16.2 Displaying Debugging InformationTo quickly diagnose problems, the debug command is useful for customers. To enabledebugging of RIP routing transactions, use the following command.Command Mode Descriptiondebug rip [all]EnableTurns on all debugging options of changed RIPinformation.debug rip events Enables a debugging of RIP event such as packettransmit and sending and changed RIP information.debug rip nsm Enables RIP nsm debugging.debug rip packet [recv | send] Shows more detailed information about RIP packet.The information includes address of packettransmission and port number.debug rip packet [recv | send]detailTo disable debugging of RIP routing transactions, use the following command.Command Mode Descriptionno debug rip [all]EnableTurns off all debugging options of changed RIPinformation.no debug rip events Disables a debugging of RIP event such as packettransmit and sending and changed RIP information.no debug rip nsm Disables RIP nsm debugging.no debug rip packet [recv | send]Disables a debugging of RIP packets.no debug rip packet [recv | send]detail
