UMN:CLI User ManualV5812G51211.5.7.5 DS1 ModeTo specify the mode of DS1, use the following command.Command Mode Descriptionds1-mode connect ds1-cpe line-length { short | long }Traffic-CESSpecifies the mode of DS1.ds1-cpe: DS1 CPE (loopback: smart jack)ds1-niu-cpe: DS1 NIU CPE (loopback: intelligent officerepeater)short: line length - short haullong: line length - long haulno-power: no power feedwith-power: with power feedds1-mode connect ds1-niu-cpepower { no-power | with-power }no ds1-mode Deletes the configured DS1 mode.11.5.7.6 Line TypeTo specify the line type used in DS3 or E3 application, use the following command.Command Mode Descriptionline-type { other | ds3-m23 | ds3-syntran | ds3-cbit-parity | ds3-clear-channel | e3-framed | e3-plcp }Traffic-CESSpecifies the line type used in a DS3 or E3 application.(mandatory for DS3 and E3 interfaces, not applicableto other interfaces)11.5.7.7 TDM Service ConfigurationIn order to configure TDM service, you need to create an TDM service ID.To create the TDM service ID and enter the configuration mode for the service, use thefollowing command.Command Mode Descriptiontdm-service SERVICE_ID mode{ pw-ip | pw-mef8 | pw-mpls } Traffic-CESCreates a TDM service ID and enters the configurationmode for the service.pw-ip: pseudowire IP transport (UDP/IP)pw-mef8: pseudowire MEF8pw-mpls: pseudowire MPLSno tdm-service SERVICE_ID Deletes the created TDM service ID.After creating a TDM service ID with pw-ip option, the prompt changes fromSWITCH(config-traffic-pf[NAME]-ces[PORT])# to SWITCH(config-traffic-pf[NAME]-ces[PORT]-svc[ID]-pw-ip)#. In this mode, you can perform the following configuration.
