UMN:CLI User ManualV5812G470To disable an ONU‘s laser, use the following command.Command Mode Descriptiononu tx-off-optic ONU-ID [<1-65525>] GPON-OLTDisables an ONU‘s laser for specified time. After thetime, the laser will be enabled.ONU-ID: 1-64 or ONU serial number1-65525: disable transceiver during input times(unit:sec)To guarantee a right operation of this feature, an ONU should be loaded with the newestfirmware.11.2.8 Source MAC address MonitoringThe V5812G can monitor its source MAC table to find a defective ONUs (ONTs). AutoONU (ONT) blocking function can be used to manage and troubleshoot the defectiveONU-related problems.To enable/disable OLT for source MAC address monitoring, use the following command.Command Mode Descriptionolt srcmac-monitor enableGPON-OLTEnables the source MAC address monitoring.olt srcmac-monitor enable auto-onu-block [expire-timeout <60-65535>]Enables the source MAC address monitoring with autoONU blocking featureauto-onu-block: When an ONU fault occurs, the systemwill disable the ONU‘s laser permanently.60-65535: expire time (second)olt srcmac-monitor disable Disables the source MAC address monitoring.To force the state of a blocked ONU ID to change to unblocked state, use the followingcommand.Command Mode Descriptiononu unblock ONU-ID GPON-OLT Forces the state of a blocked ONU ID to change tounblocked state.To force the state of a unblocked ONU ID to change to blocked state, use the followingcommand.Command Mode Descriptiononu block ONU-ID GPON-OLT Forces the state of a unblocked ONU ID to change toblocked state.!
