UMN:CLI User ManualV5812G2668.4.12 ERP TrapTo enable the system to generate ERP trap message, use the following command.Command Mode Descriptionerp trap <1-4094> {lotp | ulotp | multiple-rm |rmnode-reachability} Bridge Enables the system to send ERP Trapmessage in case of the event.To disable the system to generate ERP trap message, use the following command.Command Mode Descriptionno erp trap <1-4094> {lotp | ulotp | multiple-rm| rmnode-reachability} Bridge Disables the system to generate ERPtrapThe following options hold the configuration of the ability to transmit LOTP, ULOTP,Multiple RM or RMNode reachability Traps.– lotp: Enables/disables an RM node to transmit the LOTP traps.– ulotp: Enables/disables an RM node to transmit the ULOTP (Undirectional Loss OfTest Packets) traps.– multiple-rm: Enables/disables an RM node to transmit the trap in case of MultipleRM nodes.– rmnode-reachability: Enables/disables a normal node to transmit RMnodeReachablility traps.8.4.13 Registering ERP MACTo register MAC address of a port for ERP implementation, use the following command.Command Mode Descriptionerp register-mac VLAN PORTS Bridge Sets a register ERP MAC address.To delete the registered MAC address of a port, use the following command.Command Mode Descriptionno erp register-mac VLAN[PORTS] Bridge Deletes the registered MAC address.8.4.14 Private VLAN with ERPA protected port is for the function of port isolation in local switch. That is, it cannot workon between two different switches with protected ports. A protected port can not transmitany traffic to other protected ports.Private VLAN provides L2 isolation within the same Broadcast Domain ports. That meansanother VLAN is created within a VLAN. You can choose two types of port in ERPprotected mode.• Promiscuous: A promiscuous port can communicate with all interfaces, including the
