User Manual UMN:CLIV5812G557Step 4 Reboot the system with the new system software using the following command.Command Mode Descriptionreboot [os1 | os2] Boot Reboots the system with specified system software.os1 | os2: the area where the system software is storedIf the new system software is a current standby OS, just exit the boot mode, then theinterrupted system boot will be continued again with the new system software.To exit the boot mode, use the following command.Command Mode Descriptionexit Boot Exits the boot mode.12.3 FTP UpgradeThe system software of the V5812G can be upgraded using FTP. This will allow networkor system administrators to remotely upgrade the system with the familiar interface.To upgrade the system software using FTP, perform the following step-by-step instruction:Step 1 Connect to the V5812G with your FTP client software. To login the system, you can usethe system user ID and password.Note that you must use the command line-based interface FTP client software whenupgrading the V5812G. If you use the graphic-based interface FTP client software, thesystem cannot recognize the upgraded software.Step 2 Set the file transfer mode to the binary mode using the following command.Command Mode Descriptionbin FTP Sets the file transfer mode to the binary mode.Step 3 Enable to print out the hash marks as transferring a file using the following command.Command Mode Descriptionhash FTP Prints out the hash marks as transferring a file.Step 4 Uploads the new system software using the following command.Command Mode Descriptionput FILENAME {os1 | os2} FTPUploads the system software.FILENAME: system software file nameos1 | os2: the area where the system software is stored!
