UMN:CLI User ManualV5812G51011.5.7 TDM Service Configuration (CES UNI)This section describes the configuration of CES UNI in the ONT where the physical pathterminates and physical level functions are performed.In order to configure CES UNI and TDM service, you need to specify the CES port first.To specify the CES port, use the following command.Command Mode Descriptionces PORT Traffic-ProfileSpecifies the CES port.PORT: TDM port numberno ces PORT Deletes the CES port configuration.After opening CES Configuration mode, the prompt changes from SWITCH(config-traffic-pf[NAME])# to SWITCH(config-traffic-pf[NAME]-ces[PORT])#.11.5.7.1 Expected Circuit Pack TypeTo specify the expected circuit pack type, use the following command.Command Mode Descriptionexpected-type { auto | ds1 | e1 |c-ds1-e1 | VALUE } Traffic-CESSpecifies the expected circuit pack type.auto: Autosenseds1: DS1e1: E1c-ds1-e1: Configurable DS1/E1VALUE: 1 to 254 (according to "Table 9.1.5-1 – Circuitpack types" in "ITU-T G.984.4")11.5.7.2 Framing StructureTo specify the framing structure, use the following command.Command Mode Descriptionframing { extend-superframe |superframe | unframed | g-704 |jt-g-704 | basic-g-704 | basic-crc4 | basic-ts16 | basic-crc4-ts16 }Traffic-CES Specifies the framing structure. (mandatory for DS1interfaces)
