Operation Manual – System Maintaining and DebuggingH3C S3610&S5510 Series Ethernet Switches Chapter 3 Device Management3-1Chapter 3 Device ManagementWhen configuring device management, go to these sections for information you areinterested in:z Device Management Overviewz Configuring Device Managementz Displaying and Maintaining Device Management Configurationz Device Management Configuration ExampleNote:File names in this document comply with the following rules:z Path + file name (namely, a full file name): File on a specified path. A full file nameconsists of 1 to 135 characters.z “File name” (namely, only a file name without a path): File on the current workingpath. The file name without a path consists of 1 to 91 characters.3.1 Device Management OverviewThrough the device management function, you can view the current working state of adevice, configure running parameters, and perform daily device maintenance andmanagement.Currently, the following device management functions are available:z Rebooting a Devicez Specifying a Boot ROM File for the Next Device Bootz Upgrading Boot ROMz Configuring a Detection Intervalz Clearing the 16-bit Interface Indexes Not Used in the Current System3.2 Configuring Device Management3.2.1 Rebooting a DeviceWhen a fault occurs to a running device, you can remove the fault by rebooting thedevice, depending on the actual situation. You can set a time at which the device canautomatically reboot. You can also set a delay so that the device can automaticallyreboot in the delay.
