Operation Manual – VRRPH3C S3610&S5510 Series Ethernet Switches Chapter 1 VRRP Configuration1-24III. Configuration procedure1) Configure Switch A# Configure VLAN 2. system-view[SwitchA] vlan 2[SwitchA-vlan2] port GigabitEthernet 2/0/5[SwitchA-vlan2] quit[SwitchA] interface vlan-interface 2[SwitchA-Vlan-interface2] ip address 202.38.160.1 255.255.255.0# Create a standby group 1 and set its virtual IP address to 202.38.160.111.[SwitchA-Vlan-interface2] vrrp vrid 1 virtual-ip 202.38.160.111# Configure the priority of Switch A in the standby group to 110.[SwitchA-Vlan-interface2] vrrp vrid 1 priority 110# Configure the authentication mode of the standby group to simple and authenticationkey to hello.[SwitchA-Vlan-interface2] vrrp vrid 1 authentication-mode simple hello# Set the interval for Master to send VRRP advertisement to five seconds.[SwitchA-Vlan-interface2] vrrp vrid 1 timer advertise 5# Set the interface to be tracked.[SwitchA-Vlan-interface2] vrrp vrid 1 track interface vlan-interface 3 reduced302) Configure Switch B# Configure VLAN 2. system-view[SwitchB] vlan 2[SwitchB-vlan2] port GigabitEthernet 2/0/5[SwitchB-vlan2] quit[SwitchB] interface vlan-interface 2[SwitchB-Vlan-interface2] ip address 202.38.160.2 255.255.255.0# Create a standby group 1 and set its virtual IP address to 202.38.160.111.[SwitchB-Vlan-interface2] vrrp vrid 1 virtual-ip 202.38.160.111# Configure the authentication mode of the standby group to simple and authenticationkey to hello.[SwitchB-Vlan-interface2] vrrp vrid 1 authentication-mode simple hello# Set the interval for Master to send VRRP advertisement to five seconds.[SwitchB-Vlan-interface2] vrrp vrid 1 timer advertise 53) Verify the configuration
