Operation Manual – IPv4 RoutingH3C S3610&S5510 Series Ethernet Switches Chapter 3 OSPF Configuration3-22Task RemarksConfiguring OSPF Route Summarization OptionalConfiguring OSPF Inbound Route Filtering OptionalConfiguring ABR Type-3 LSA Filtering OptionalConfiguring an OSPF Cost for an Interface OptionalConfiguring the Maximum Number of OSPF Routes OptionalConfiguring the Maximum Number of Load-balancedRoutes OptionalConfiguring a Priority for OSPF OptionalConfiguringOSPF RouteControlConfiguring OSPF Route Redistribution OptionalConfiguring OSPF Packet Timers OptionalSpecifying an LSA Transmission Delay OptionalSpecifying SPF Calculation Interval OptionalSpecifying the LSA Minimum Repeat Arrival Interval OptionalSpecifying the LSA Generation Interval OptionalDisabling Interfaces from Sending OSPF Packets OptionalConfiguring Stub Routers OptionalConfiguring OSPF Authentication OptionalAdding the Interface MTU into DD Packets OptionalConfiguring the Maximum Number of External LSAsin LSDB OptionalMaking External Route Selection Rules Defined inRFC1583 Compatible OptionalLogging Neighbor State Changes OptionalConfiguring OSPF Network Management OptionalConfiguringOSPF NetworkOptimizationEnabling the Advertisement and Reception ofOpaque LSAs OptionalConfiguring the OSPF GR Capability OptionalConfiguring the OSPF GR Helper OptionalConfiguringOSPFGracefulRestart Triggering OSPF Graceful Restart Optional3.3 Configuring OSPF Basic FunctionsYou need to enable OSPF, specify an interface and area ID first before performing othertasks.
