Operation Manual – AAA-RADIUS-HWTACACSH3C S3610&S5510 Series Ethernet SwitchesChapter 1 AAA/RADIUS/HWTACACSConfiguration1-29To do… Use the command… RemarksSet the status of the primaryRADIUSauthentication/authorizationserverstate primaryauthentication { active |block }Set the status of the primaryRADIUS accounting serverstate primary accounting{ active | block }Set the status of thesecondary RADIUSauthentication/authorizationserverstate secondaryauthentication { active |block }Set the status of thesecondary RADIUSaccounting serverstate secondaryaccounting { active |block }Optionalactive for everyserver configuredwith IP address in theRADIUS schemeNote:z If both the primary server and the secondary server are in the blocked state, it isnecessary to manually turn the secondary server to the active state so that thesecondary server can perform authentication. If the secondary server is still in theblocked state, the primary/secondary switchover cannot take place.z If one server is in the active state while the other is blocked, the primary/secondaryswitchover will not take place even if the active server is not reachable.1.4.8 Configuring Attributes Related to the Data Sent to the RADIUS ServerFollow these steps to configure the attributes related to the data sent to the RADIUSserver:To do… Use the command… RemarksEnter system view system-view —Enable the RADIUS trapfunctionradius trap{ accounting-server-down |authentication-server-down }OptionalDisabled by defaultCreate a RADIUS schemeand enter RADIUSscheme viewradius schemeradius-scheme-nameRequiredNot defined by defaultSpecify the format of theusername to be sent to aRADIUS serveruser-name-format{ with-domain |without-domain }OptionalBy default, the ISPdomain name is includedin the username.
