Operation Manual – NQAH3C S3610&S5510 Series Ethernet Switches Chapter 1 NQA Configuration1-15To do… Use the command… RemarksView the recorded delayjitter of UDP packettransmission in the lastNQA jitter testdisplay nqa jitter[ admin-nameoperation-tag ]OptionalAvailable in any view.Note:The number of probes made in a jitter test depends on the count command, while thenumber of test packets sent in each probe depends on the jitter-packetnumcommand.II. Configuration example1) Network requirementsUse the NQA jitter function to test the delay jitter of packet transmission between thelocal port (Switch A) and the specified destination port (Switch B).2) Network diagramFigure 1-6 Network diagram for the jitter test3) Configuration procedurez Configuration on Switch B# Enable the NQA server and configure the listening IP address and port number. system-view[SwitchB] nqa-server enable[SwitchB] nqa-server udpecho 10.2.2.2 9000z Configuration on Switch A# Enable the NQA client, create a jitter test group, and configure related testparameters. system-view[SwitchA] nqa-agent enable[SwitchA] nqa admin jitter[SwitchA-nqa-admin-jitter] test-type jitter[SwitchA-nqa-admin-jitter] destination-ip 10.2.2.2[SwitchA-nqa-admin-jitter] destination-port 9000
