Operation Manual – VRRPH3C S3610&S5510 Series Ethernet Switches Chapter 1 VRRP Configuration1-29Config Pri : 100 Run Pri : 100Preempt Mode : YES Delay Time : 0Auth Type : NONEVirtual IP : 202.38.160.111Master IP : 202.38.160.1Interface : Vlan-interface2VRID : 2 Adver. Timer : 1Admin Status : UP State : MasterConfig Pri : 110 Run Pri : 110Preempt Mode : YES Delay Time : 0Auth Type : NONEVirtual IP : 202.38.160.112Virtual MAC : 0000-5e00-0102Master IP : 202.38.160.2The above information indicates that in standby group 1 Switch A is the master, SwitchB is the backup and the host with the default gateway of 202.38.160.111/24 accessesthe Internet through Switch A; in standby group 2 Switch A is the backup, Switch B isthe master and the host with the default gateway of 202.38.160.112/24 accesses theInternet through Switch B.1.5 IPv6-Based VRRP Configuration ExamplesThis section provides these configuration examples:z Single VRRP Standby Group Configuration Examplez VRRP Interface Tracking Configuration Examplez Multiple VRRP Standby Group Configuration Example1.5.1 Single VRRP Standby Group Configuration ExampleI. Network requirementsz Host A needs to access Host B on the Internet, using FE80::10 as its defaultgateway.z Switch A and Switch B belong to standby group 1 with the virtual IP address ofFE80::10.z If Switch A operates normally, packets sent from Host A to Host B are forwardedby Switch A; if Switch A fails, packets sent from Host A to Host B are forwarded bySwitch B.
