Operation Manual – Multicast ProtocolH3C S3610&S5510 Series Ethernet Switches Chapter 6 PIM Configuration6-20z Bootstrap timeout timez An ACL rule defining a legal C-RP address range and the range of multicastgroups to be servedz C-RP-Adv intervalz C-RP timeout timez The IP address of a static RPz An ACL rule for register message filteringz Register suppression timeout timez Probe timez ACL rules and ACL order for disabling RPT-to-SPT switchover6.3.3 Enabling PIM-SMWith PIM-SM enabled, a router sends hello messages periodically to discover PIMneighbors and processes messages from PIM neighbors. When deploying a PIM-SMdomain, you are recommended to enable PIM-SM on all interfaces of non-borderrouters (border routers are PIM-enabled routers located on the boundary of BSRadmin-scope regions).Follow these steps to enable PIM-SM:To do... Use the command... RemarksEnter system view system-view —Enable IP multicastroutingmulticastrouting-enableRequiredDisable by defaultEnter Ethernet port view interface interface-typeinterface-number —Enable PIM-SM pim sm RequiredDisabled by defaultCaution:All the interfaces of the same router must work in the same PIM mode.
