Operation Manual – VRRPH3C S3610&S5510 Series Ethernet Switches Chapter 1 VRRP Configuration1-21II. Network diagramHost ASwitch ASwitch BVirtual IP address:202.38.160.111/24Vlan-int2202.38.160.1/24Vlan-int2202.38.160.2/24Host B202.38.160.3/24203.2.3.1/24InternetFigure 1-7 Network diagram for single VRRP standby group configurationIII. Configuration procedure1) Configure Switch A# Configure VLAN 2. system-view[SwitchA] vlan 2[SwitchA-vlan2] port GigabitEthernet 2/0/5[SwitchA-vlan2] quit[SwitchA] interface vlan-interface 2[SwitchA-Vlan-interface2] ip address 202.38.160.1 255.255.255.0# Create standby group 1 and set its virtual IP address to be 202.38.160.111.[SwitchA-Vlan-interface2] vrrp vrid 1 virtual-ip 202.38.160.111# Set the priority of Switch A in standby group 1 to 110.[SwitchA-Vlan-interface2] vrrp vrid 1 priority 110# Set Switch A to work in preemption mode. The preemption delay is five seconds.[SwitchA-Vlan-interface2] vrrp vrid 1 preempt-mode timer delay 52) Configure Switch B# Configure VLAN 2. system-view[SwitchB] vlan 2[SwitchB-Vlan2] port GigabitEthernet 2/0/5[SwitchB-vlan2] quit[SwitchB] interface vlan-interface 2[SwitchB-Vlan-interface2] ip address 202.38.160.2 255.255.255.0
