Operation Manual – Multicast ProtocolH3C S3610&S5510 Series Ethernet Switches Chapter 6 PIM Configuration6-196.3 Configuring PIM-SMNote:A device can serve as a C-RP and a C-BSR at the same time.6.3.1 PIM-SM Configuration Task ListComplete these tasks to configure PIM-SM:Task RemarksConfiguring PIM-SM RequiredPerforming basic C-BSR configuration OptionalConfiguring a global-scope C-BSR OptionalConfiguring an admin-scope C-BSR OptionalConfiguring a BSR admin-scoperegion boundary OptionalConfiguring a BSRConfiguring global C-BSR parameters OptionalConfiguring a static RP OptionalConfiguring a C-RP OptionalEnabling auto-RP OptionalConfiguring an RPConfiguring C-RP timers OptionalConfiguring PIM-SM Register Messages OptionalDisabling RPT-to-SPT Switchover OptionalConfiguring PIM Common Information Optional6.3.2 Configuration PrerequisitesBefore configuring PIM-SM, complete the following task:z Configure any unicast routing protocol so that all devices in the domain areinteroperable at the network layer.Before configuring PIM-SM, prepare the following data:z An ACL rule defining a legal BSR address rangez Hash mask length for RP selection calculationz C-BSR priorityz Bootstrap interval
