Operation Manual – IPv6H3C S3610&S5510 Series Ethernet Switches Chapter 1 IPv6 Basics Configuration1-25To do… Use the command… RemarksClear IPv6 dynamic domainname cache information reset dns ipv6 dynamic-hostClear FIB cache entries reset ipv6 fibcacheClear IPv6 neighbor informationreset ipv6 neighbors { all |dynamic | interfaceinterface-type interface-number |static }Clear the corresponding PMTU reset ipv6 pathmtu { all | static |dynamic}Clear the statistics of IPv6 andICMPv6 packets reset ipv6 statisticsClear all IPv6 TCP connectionstatistics reset tcp ipv6 statisticsClear the statistics of all IPv6UDP packets reset udp ipv6 statisticsAvailable inuser viewNote:The display dns domain command is the same as the one of IPv4 DNS. For detailsabout the commands, refer to DNS Commands.1.11 IPv6 Configuration ExampleI. Network requirementsTwo switches are directly connected through two Ethernet ports. The Ethernet portsbelong to VLAN 2. Configure different types of IPv6 addresses for VLAN-interface 2respectively on Switch A and Switch B to verify the connectivity between two switches.The IPv6 prefix in the EUI-64 format is 2001::/64. Specify the aggregatable globalunicast address of Switch A as 3001::1/64, and the aggregatable global unicastaddress of Switch B as 3001::2/64.II. Network diagramSwitch A Switch BVlan-int2 Vlan-int2Figure 1-6 Network diagram for IPv6 address configuration
