Operation Manual – IPv6 RoutingH3C S3610&S5510 Series Ethernet Switches Chapter 3 IPv6 OSPFv3 Configuration3-153.8 OSPFv3 Configuration Examples3.8.1 Configuring OSPFv3 AreasI. Network requirementsIn the following figure, all switches run OSPFv3. The AS is split into three areas, inwhich, Switch B and Switch C act as ABRs to forward routing information betweenareas.It is required to configure Area 2 as a stub area, reducing LSAs into the area withoutaffecting route reachability.II. Network diagramOSPFv3Area 0OSPFv3Area 1OSPFv3Area 2Switch AVlan-int1002001::2/64Vlan-int1002001::1/64Vlan-int3002001:3::1/64Vlan-int2002001:1::2/64Switch CVlan-int4002001:2::1/64Vlan-int4002001:2::2/64Switch BVlan-int2002001:1::1/64Switch DStubFigure 3-2 Network diagram for OSPFv3 area configurationIII. Configuration procedure1) Configure IPv6 addresses for interfaces (omitted)2) Configure OSPFv3 basic functions# Configure Switch A. system-view[SwitchA] ipv6[SwitchA] ospfv3[SwitchA-ospfv3-1] router-id 1.1.1.1[SwitchA-ospfv3-1] quit[SwitchA] interface vlan-interface 300[SwitchA-Vlan-interface300] ospfv3 1 area 1[SwitchA-Vlan-interface300] quit[SwitchA] interface vlan-interface 200[SwitchA-Vlan-interface200] ospfv3 1 area 1[SwitchA-Vlan-interface200] quit# Configure Switch B
