Operation Manual – Link AggregationH3C S3610&S5510 Series Ethernet Switches Chapter 2 Link Aggregation Configuration2-2addresses or black hole MAC addresses configured, voice VLAN-enabled ports,or 802.1x-enabled ports.z After you remove a manual aggregation group, all the ports in the group aredismissed from it.z For a manual aggregation group containing only one port, the only way to removethe port from it is to remove the aggregation group.z To make an aggregation group function properly, make sure that theselected/unselected state of the ports at both ends of a link is consistent.2.1.2 Configuring a Static LACP Link Aggregation GroupFollow these steps to configure a static aggregation group:To do… Use the command… RemarksEnter system view system-view ––Configure the systemLACP prioritylacp system-prioritysystem-priorityOptional32768 by default.Changing system LACPpriority can affect theselected/unselected stateof the ports in the group.Create a static LACPaggregation grouplink-aggregation groupagg-id mode static RequiredEnter Ethernet port view interface interface-typeinterface-number ––Configure the port LACPprioritylacp port-priorityport-priorityOptional32768 by default.Changing port LACPpriority can affect theselected/unselected stateof the ports in the group.Assign the Ethernet portto the aggregation groupport link-aggregationgroup agg-id RequiredNote that:z You can create a static aggregation group by changing the type of an existingmanual link aggregation group that contains no port.z An aggregation group cannot contain the following ports: RRPP-enabled ports,reflector ports or destination ports of port mirroring groups, ports configured withstatic MAC addresses or black hole MAC addresses, voice VLAN-enabled ports,or 802.1x-enabled ports.z After you remove a static aggregation group, all the ports in the group aredismissed from it, and LACP is disabled on the ports.
