Operation Manual – IPv6 RoutingH3C S3610&S5510 Series Ethernet Switches Chapter 1 IPv6 Static Routing Configuration1-31.4 IPv6 Static Routing Configuration ExampleI. Network requirementsWith IPv6 static routes configured, all hosts and switches can interact with each other.II. Network diagramFigure 1-1 Network diagram for static routesIII. Configuration procedure1) Configure the IPv6 addresses of all VLAN interfaces (Omitted)2) Configure IPv6 static routes.# Configure the default IPv6 static route on Switch A. system-view[SwitchA] ipv6[SwitchA] ipv6 route-static :: 0 4::2# Configure two IPv6 static routes on Switch B. system-view[SwitchB] ipv6[SwitchB] ipv6 route-static 1:: 64 4::1[SwitchB] ipv6 route-static 3:: 64 5::1# Configure the default IPv6 static route on Switch C. system-view[SwitchC] ipv6[SwitchC] ipv6 route-static :: 0 5::23) Configure the IPv6 addresses of hosts and gateways.Configure the IPv6 addresses of all the hosts based upon the network diagram,configure the default gateway of Host A as 1::1, that of Host B as 2::1, and that of HostC as 3::1.
