Operation Manual – RRPPH3C S3610&S5510 Series Ethernet Switches Chapter 1 RRPP Configuration1-19Figure 1-7 Single ring networking diagramII. Configuration considerationsFirst, determine the node mode of a device in an RRPP ring, and then perform thefollowing configurations on a per-device basis:z Create an RRPP domain.z Specify the control VLAN for the RRPP domain.z Specify the node mode of a device on the primary ring and the ports accessing theRRPP ring on the device.z Enable the RRPP ring.z Enable RRPPIII. Configuration procedure1) Perform the following configuration on Device A: system-view[Device A] rrpp domain 1[Device A-rrpp-domain1] control-vlan 4092[Device A-rrpp-domain1] ring 1 node-mode master primary-port ethernet 1/0/1secondary-port ethernet 1/0/2 level 0[Device A-rrpp-domain1] ring 1 enable[Device A-rrpp-domain1] quit[Device A] rrpp enable2) Perform the following configuration on Device B: system-view[Device B] rrpp domain 1[Device B-rrpp-domain1] control-vlan 4092[Device B-rrpp-domain1] ring 1 node-mode transit primary-port ethernet 1/0/1secondary-port ethernet 1/0/2 level 0
