Electra Elite IPK Document Revision 4Programming Manual 2 - 87______________________________________________________________________________________________________________________________________________________________________1-1-67 OCC Table AssignmentGeneral DescriptionUse this Memory Block to assign an Other Common Carrier (OCC) code (8-digitmaximum) in a table. A maximum of 16 codes can be assigned.DisplayRelated ProgrammingRefer to Chapter 3 Advanced Applications, Section 1 Code Restriction on page 3-1.Programming Procedures1 Go off-line.2 Press LK1 + LK1 + FG to access the Memory Block.3 Use the dial pad to enter the data. Use the following to enter data:Jto move the cursor leftLto move the cursor rightK~Ito enter numeric dataH to clear data The information that can be entered includes:OCC Table: 01~16 (8-digit) Setting Data: 0~9, , #, NANP = X, P, N (Maximum eight digits) Operation data includes:Default ValuesOCC Table 01 ~ 15 BlankOCC Table 16 1010XXX4 Press G to write the data and advance to the next OCC table.5 Repeat Steps 3 and 4 for each OCC Table. The next Memory Block is displayed.6 Program the next Memory Block or press E to go back on-line.System Mode1Submode1Data No.67PC Programming¦+ACDataNo6 7 : ( 0 1 ) =T I M E D I S P L A YOCCTable01~16SettingDataOperationData Dial Number OperationX K~I,J,L B + GP KandA B + HN B~I B + I J B + J# L B + L
