2 - 262 Memory Blocks______________________________________________________________________________________________________________________________________________________________________Document Revision 4 Electra Elite IPK1-9-02 DISA Password Effect/InvalidSelectionGeneral DescriptionUse this Memory Block to specify whether or not a Direct Inward System Access(DISA) Password is required. When NO is assigned, the calling party can use theDISA feature without a DISA Password.This Memory Block is automatically displayed after data is written for each ID BufferNo. (01~CO for Electra Elite 192 or 01~48 for Electra Elite 48) in Memory Block1-9-00. After password selection is entered, the next sequential ID Buffer NO. isdisplayed on Memory Block 1-9-00. This cycle is repeated until all DISA ID codes areassigned, and then cycles back to ID Buffer No. 1. Programming does notautomatically cycle to Memory Block 1-10-00.DisplaySettingsRelated ProgrammingRefer to individual features in the Electra Elite IPK Features and Specifications Manual.LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shadedselection is thedefault.NO YSProgramming Procedures1 Go off-line.2 Press LK1 + LK9 + JB to access the Memory Block.3 Press the corresponding CO/PBX line key to change the data option.Setting Data:NO (LK1) = DISA Password is not required.YS (LK2) = DISA Password is required. Assign with MB 1-1-46~48 [Access Code (1-,2-, or 3-Digit) Assignment].4 Press G to write the data and return to the next Memory Block 1-9-00.5 After last DISA ID Password decision is made, press G to write the data and return to Buffer No. 01 on Memory Block 1-9-00.6 Press E to go back on-line.System Mode1Submode9Data No.02PC Programming¦+BD0 1 / 0 2 : P A S W O R D = Y ST I M E D I S P L A YID BufferNo.(01~CO) TitleDataNo.SettingData
