Electra Elite IPK Document Revision 4Programming Manual 2 - 387______________________________________________________________________________________________________________________________________________________________________1-16-04 VLAN Mode SelectionGeneral DescriptionUse this Memory Block to specify whether or not IEEE 802.1q VLAN Tagging isenabled for each HUB(8)-U( ) ETU. This Memory Block must also be enabled to useIEEE 802.p Priority. Priority options can be enabled in Memory Block 1-16-06 (PortBased Priority Selection), Memory Block 1-16-07(High Priority RX Tag Threshold),Memory Block 1-16-08 (High Priority TX Tag Assignment), and Memory Block 1-16-09(Low Priority TX Tag Assignment).R1500 or higher is required.DisplaySettingsLK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shadedselection is thedefault.NO YSProgramming Procedures1 Go off-line.2 Press LK1 + LK16 +JJKD to access the Memory Block.3 Press the corresponding CO/PBX line key to change the Setting Data option.4 Press G to write the data.5 Repeat steps 3 and 4 for each HUB(8)-U( ) ETU.6 Press E to go back on-line.System Mode1Submode16Data No.04PC Programming¦+AB0 4 : 1 V L A N N OT I M E D I S P L A YDataNo.SettingDataTitleHUB1~3
