Electra Elite IPK Document Revision 4Programming Manual 2 - 341______________________________________________________________________________________________________________________________________________________________________1-15-04 Destination Point Code AssignmentGeneral DescriptionUse this Memory Block to assign the Destination Point Code for each CommonSignaling Channel.DisplayProgramming Procedures1 Go off-line.2 Press LK1 + LK15 + KD to access the Memory Block.3 Use dial pad keys to enter Setting Data. Use the following to enter data:Jto move cursor leftLto move cursor rightK~ Ito enter numeric data Point Code Range is 00001~16367.Default Values :Blank4 Press G to write the data.5 Press E to go back on-line.Related ProgrammingM.B. Number Memory Block Name7-1 Card Interface Slot Assignment7-3-01 MIF (LCR) Assignment7-3-02 MIF (SMDR) Assignment1-15-00 K-CCIS Main/Remote Office Selection1-15-01 Common Signal Channel Data Speed Assignment1-15-02 Common Signal Channel Assignment1-15-03 Originating Point Code Assignment1-15-05 Destination Point Code Transfer Assignment1-15-06 Originating Office Code Number Assignment1-15-07 K-CCIS Message Response Timeout AssignmentSystem Mode1Submode15Data No.04PC Programming¦+AW0 4 : D S T C C H 1T I M E D I S P L A YTitle SettingDataDataNo.C-Channel1~4
