2 - 500 Memory Blocks___________________________________________________________________________________Document Revision 4 Electra Elite IPK___________________________________________________________________________________3-92 Trunk (Installed, DP/DTMF)SelectionGeneral DescriptionUse this Memory Block to specify an external line as DP (10 pps or 20 pps), DTMFline, or not connected (NIL).DisplaySettings Notes LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shadedselection is thedefault.NIL DP 10pps DP 20pps MFProgramming Procedures1 Go off-line.2 Press LK3 + G + IB to access the Memory Block.3 Press line key to specify external line as DP or DTMF for CO/PBX No. Use the following to enter data:Jto move the cursor leftLto move the cursor rightK~Ito enter numeric data or CO/PBX No.– OR –D to go to the next assigned CO/PBX No.4 Press G to write the selected data and display the next CO/PBX No. for Memory Block 3-90. After CO/PBX No. 64 isentered, CO/PBX No. 01 is again displayed on Memory Block 3-90.Related ProgrammingM.B. Number Memory Block Name3-14 Tie Line Type Assignment4-12 Line Key Selection for Telephone ModeOnly Tie lines and Direct Inward Dialing (DID) trunks can use dial pulse on the Electra Elite system. All othertrunks must be set to multifrequency (MF).CO/PBX Line Mode3Submode—Data No.92PC Programming¦+BCT0 1 / 9 2 : M FT I M E D I S P L A YSettingDataDataNo.CO/PBXNo.(01~64)
