2 - 446 Memory Blocks___________________________________________________________________________________Document Revision 4 Electra Elite IPK___________________________________________________________________________________3-20 Tie Line Loop Off-Guard TimeSelectionGeneral DescriptionUse this Memory Block to assign loop off-guard time to prevent noise that could causethe system to be unable to answer an incoming Tie line.DisplaySettingsPage 1LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8The shadedselection is thedefault. Timesare in seconds.0.0 0.5 1.0 1.5 2.0 3.0 4.0. 5.0Page 2LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 86.0 7.0 8.0 9.0 10.0 11.0 12.0 13.0Programming Procedures1 Go off-line.2 Press LK3 + G + BK to access the Memory Block.3 Press the corresponding CO/PBX line key to change loop off-guard time for CO/PBX No. Use the following to enter data:Jto move the cursor leftLto move the cursor rightK~Ito enter numeric data or CO/PBX No.– OR –D to go to the next assigned CO/PBX No.C to go to the next pageA to go to the previous page4 Press G to write the data and display the next Memory Block.5 Program the next Memory Block or press E to go back on-line.CO/PBX Line Mode3Submode—Data No.20PC Programming¦+ALM0 1 / 2 0 : L O O P 2 . 0 | 1T I M E D I S P L A YCO/PBXNo.(01~64)DataNo. TitlePageNo.SettingData
