Electra Elite IPK Document Revision 4Programming Manual 2 - 391______________________________________________________________________________________________________________________________________________________________________1-16-06 Port Based Priority SelectionGeneral DescriptionUse this memory block to specify how frames, reaching the ingress port without VLANtags are marked for queuing internally in the HUB(8). The HUB(8) has two queues:High Priority and Low Priority. When the frame reaches the egress port, settings forMemory Blocks 1-16-08 (for High Priority frames) and 1-16-09 (for Low Priorityframes) for the egress port are used to convert the low or high priority queue to aVLAN tag priority (0~7). Set to NO (default), this Memory block does not mark framesfor either queue; Memory Block 1-16-07 then determines the priority queue for wherethe frame is sent.R1500 or higher is required.DisplaySettingsLK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shadedselection is thedefault.NO(NotAssigned)LOLowHIHighProgramming Procedures1 Go off-line.2 Press LK1 + LK16 + JJKF to access the Memory Block.3 Press the corresponding CO/PBX line key to change the Setting Data option.4 Press G to write the data.5 Repeat steps 3 and 4 for each HUB(8)-U( ) ETU.6 Press E to go back on-line.System Mode1Submode16Data No.06PC Programming¦+AB0 6 : 1 - 1 Q o S N OT I M E D I S P L A YDataNo.SettingDataTitlePORT1~8HUB1~3
