Electra Elite IPK Document Revision 4Programming Manual 2 - 393______________________________________________________________________________________________________________________________________________________________________1-16-07 High Priority RX Tag ThresholdGeneral DescriptionThe HUB(8) has two queues: High Priority and Low Priority. When Memory Block1-16-06 is set to NO, and the priority of the VLAN tag is equal to or greater than thesetting in this block, the tag is queued for high priority. Otherwise, it is queued for lowpriority. When it is transmitted out the egress port of the HUB(8), it retains its originalVLAN tag priority value.R1500 or higher is required.DisplayProgramming Procedures1 Go off-line.2 Press LK1 + LK16 + JJKG to access the Memory Block.3 Use dial pad keys to enter Setting data. Use the following to enter data:Use Jto move cursor leftUse Lto move cursor rightUse K~ Ito enter numeric data Priority range is lowest 0~7 highest.Default Values:All ports = 74 Press G to write the data.5 Repeat steps 3 and 4 for each HUB(8)-U( ) ETU port.6 Press E to go back on-line.System Mode1Submode16Data No.07PC Programming¦+AB0 7 : 1 - 1 H I G H R X = 7T I M E D I S P L A YDataNo.SettingDataTitlePORT1~8HUB1~3
