Electra Elite IPK Document Revision 4Programming Manual 2 - 495______________________________________________________________________________________________________________________________________________________________________3-73 CO Message Waiting Yes/No SelectionGeneral DescriptionUse this Memory Block to specify whether or not the CO Message Waiting feature isallowed per CO/PBX Line.R2000 or higher is required.DisplaySettingsLK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shadedselection is thedefault.NO YESProgramming Procedures1 Go off-line.2 Press LK3 + G + GC to access the Memory Block. Use the following to enter data:Jto move the cursor leftLto move the cursor rightK~Ito enter numeric data or CO/PBX No.– OR –D to go to the next assigned CO/PBX No.Default ValuesCO/PBX No. 01~64 = NO3 Press the corresponding CO/PBX line key to change the Setting Data option.4 Press G to write the selected data and display Memory Block 3-00 CO/PBX 02. After the last CO/PBX is programmed,CO/PBX 01 is displayed again.Related ProgrammingM.B. Number Memory Block Name1-8-07 Class of Service (Attendant) Feature Selection 1Page 3, LK 24-69 CO Message Waiting Indication AssignmentCO/PBX Line Mode3Submode—Data No.73PC Programming¦+BCT0 1 / 7 3 : C O M W N OT I M E D I S P L A YCO/PBXNo.(01~64)DataNo. SettingDataTitle
