NEC Electra Elite IPK Programming Manual

Also see for ElectraElite IPK: User manual User guide User guide User guide Attendant user guide

Contents

NEC Electra Elite IPK Programming Manual Manual pdf 503 page image

2 - 426 Memory Blocks___________________________________________________________________________________Document Revision 4 Electra Elite IPK___________________________________________________________________________________3-02 Trunk Status SelectionUse this Memory Block to specify whether a CO/PBX line is used for call originationand termination or termination only.DisplaySettingsLK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK8 The shadedselection is thedefault.OUT&IN INProgramming Procedures1 Go off-line.2 Press LK3 + G to access the Memory Block.3 Press the corresponding CO/PBX Line Key to change the option. Use the following to enter data:Jto move the cursor leftLto move the cursor rightK~Ito enter numeric data or CO/PBX No.– OR –D to go to the next assigned CO/PBX No.4 Press G to write the data and display the next Memory Block.5 Program the next Memory Block or press E to go back on-line.CO/PBX Line Mode3Submode—Data No.02PC Programming¦+BCT0 1 / 0 2 : O U T & I NT I M E D I S P L A YCO/PBXNo.(01~64) Setting DataDataNo. Setting Data