Electra Elite IPK Document Revision 4Programming Manual 3 - 33______________________________________________________________________________________________________________________________________________________________________Call by Call Service Parameter Assignment..................... 1-10-07Call by Call Max Digit Assignment.................................... 1-10-08Call by Call Simulated Facility Group Assignment............ 1-10-09Call by Call Outgoing SFG Assignment............................ 1-10-20Call by Call Outgoing/Incoming SFG Assignment.............1-10-21Call by Call Incoming Type Selection................................1-10-223.3 Memory Block Description3.3.1 DID Digit Length Selection (Memory Block 1-1-20)Use this Memory Block to define the number of DID digits.Default: 33.3.2 DID Digit Conversion Assignment (Memory Block 1-1-21)Use this Memory Block to enable the DID Digit Conversion table.Default: NO3.3.3 DID Digit Conversion Table (Memory Block 1-1-22)Use this Memory Block to assign DID numbers to ring at stationnumbers, closed number (plus outgoing digits), or tenant number.Default: Not Specified3.3.4 DID Forward Station Number for Busy Station or Undefined Digit(Memory Block 1-1-23)Use this Memory Block when the DID conversion Table is enabled todefine where digits are routed when undefined or the station is busy.Default: NON (Not Assigned)3.3.5 Access Code (1-, 2-, or 3-Digit) Assignment (Memory Block1-1-46~48)Use this Memory Block to assign access codes or station numbers.Function 080 [Outgoing (CO only) Access in same Tenant] defaultNot Specified, Function 101(Trunk Group 01) default is 9, andFunction 201~232 (Route Advance Blocks 1~32) default is nonespecified.
