Electra Elite IPK Document Revision 4Programming Manual 2 - 471______________________________________________________________________________________________________________________________________________________________________3-42 DIT AssignmentGeneral DescriptionUse this Memory Block to assign a Day Mode direct trunk termination to anindependent station.R2500 is required for 5-, 6-, or 7-digit Extension Numbers.Display (R1700 or lower)Display (R2000 or higher) The number displayed after DIT (XXX) is from Memory Block 1-2-34 (Expanded Station Number Assignment) when assigned(R2500 is required).Programming Procedures1 Go off-line.2 Press LK3 + G + DBto access the Memory Block.3 Enter data for CO/PBX No. using the dial pad to assign DIT to a station. Use the following to enter data:Jto moves the cursor leftLto moves the cursor rightK~Ito enter numeric data or CO/PBX No.– OR –D to go to the next assigned CO/PBX Line No. Enter the following:Station No. (2-, 3-, or 4-digits 10~8999)CO Port No. (01~64)Default ValuesNo Assignment4 Press G to write the data and display the next Memory Block.CO/PBX Line Mode3Submode—Data No.42PC Programming¦+BCT0 1 / 4 2 : D I T D —T I M E D I S P L A YDataNo. Setting Data(Incoming)CO/PBXNo.(01~64) Title0 1 / 4 2 : D I T X X XT I M E D I S P L A YDataNo. Setting Data(Incoming)CO/PBXNo.(01~64) Title
