2 - 442 Memory Blocks___________________________________________________________________________________Document Revision 4 Electra Elite IPK___________________________________________________________________________________3-18 Tie Line Release Detect TimeSelectionGeneral DescriptionUse this Memory Block to specify the time before the circuit disconnect detected onthe Tie line on the distant system side is recognized as Tie line release.DisplaySettingsPage 1LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shadedselection is thedefault. Timesare inmilliseconds.0 130 260 390 520 650 780 910Page 2LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 81040 1170 1300 1430 1560 1690 1820 1950Programming Procedures1 Go off-line.2 Press LK3 + G + AH to access the Memory Block.3 Press the corresponding CO/PBX line key to change release detect time for CO/PBX No. Use the following to enter data:Jto move the cursor leftLto move the cursor rightK~Ito enter numeric data or CO/PBX No.– OR –D to go to the next assigned CO/PBX No.C to go to the next pageA to go to the previous page4 Press G to write the data and display the next Memory Block.5 Program the next Memory Block or press E to go back on-line.CO/PBX Line Mode3Submode—Data No.18PC Programming¦+ALM0 1 / 1 8 : R L S 5 2 0 | 1T I M E D I S P L A YCO/PBXNo.(01~64)DataNo. Title PageSettingData
